Wiring Procedure - Oval ALTI mass Series Instructions Manual

3.2 Procedure of wiring
3.2 Procedure of wiring
Converter and sensor unit are connected with a dedicated cable. The maximum length of dedicated cable
L-770HP--E
varies depending on the type of sensor unit.
Converter and sensor unit are connected with a dedicated cable. The maximum length of dedicated cable
varies depending on the type of sensor unit.
■ How to remove the front cover of converter

6.2 Wiring Procedure

■ How to remove the front cover of converter
The wiring connection terminal of converter exists on the front surface of case. Remove the front cover of
Terminals for wiring connections are found at the front of transmitter housing. Remove the front cover
converter following the procedure shown below.
The wiring connection terminal of converter exists on the front surface of case. Remove the front cover of
using below procedure.
converter following the procedure shown below.
WARNING:
WARNING: Be sure to turn off power before opening the terminal box.
WARNING:
Be sure to turn OFF the power supply before wiring.
Be sure to turn OFF the power supply before wiring.
(1)
(1)
(1) Loosen the screw (M3)
(The cover can be removed by loosening
(1) Loosen the screw (M3)
the screw without unscrewing completely)
(The cover can be removed by loosening
the screw without unscrewing completely)
The cable should have 100 to 150mm of marginal cable length secured at the position shown below
so that the internal device can be pulled out from the case while connected.
The cable should have 100 to 150mm of marginal cable length secured at the position shown below
so that the internal device can be pulled out from the case while connected.
6
6

M3 screw
M3 screw
Cover
Cover
(2)
Slide the cover
(2)
upward
Slide the cover
upward
(2)
(2)
(3)
(3)
Fig.6.2
Fig.6.3
Lift to remove
the forward
Lift to remove
the forward
Tab
Tab
Slide the cover upward.
Slide the cover upward. (As the cover is fixed by 2 tabs, slide the cover
upward putting additional force)
(As the cover is fixed by 2 tabs, slide the cover
upward putting additional force)
Remove by lifting the cover.
Remove by lifting the cover.
Sensor cable
Sensor cable
Power cable
Power cable
(3)
(3)