Transmitter Installation - Oval ALTI mass Series Instructions Manual

L-770HP--E
3. Installation of converter (PA5K) / procedure of wiring

5.8 Transmitter Installation

3.1 Procedure of installation
() Locate the meter sufficiently away from mechanical vibration or from corrosive gas atmosphere.
(1) Select a place where there is few mechanical vibration and corrosive gas.
() Locate the meter where humidity is low and where temperature is as moderate as possible.
(2) Select a place where there the humidity is low and the temperature is almost ordinary temperature.
() Installation pitch between  rackmount transmitters shall be more than 0mm for environment
(3) To install more than one converter under an environment where the ambient temperature of converter
where ambient temperature exceeds 0degC.
exceeds 40°C, the attachment pitch should be 60mm or more.
() Install in a location easy to access for inspection and maintenance.
(4) Install the product at a place where you can carry out the maintenance easily.
() Install the transmitter with the dimensions shown in the figure below.
(5) Attach the converter with the attachment dimensions
2-?7 /1 unit

* Installation pitch between 2 rackmount
transmitters shall be more than 60mm for
environment where ambient temperature
*
Min 50 exceeds 40degC.
Fig..
48
44
?4.5
Fig.3.1 Converter external dimensions diagram
Rack
165
3.8
121.2
E-454-1-E
Unit: mm
Unit: mm
Rack
5