L-770HP--E
6.5.5 Recommended cables condition
Classification
Terminal
Power supply
ANALOG,
PULSE
Signal
STATUS I/O
RS-
NOTE:
For the signal cable, use the shielded cable.
6.6 Insulation Resistance / Withstand Voltage Test
Noise reduction parts are equipped between the power supply line and the grounding and between the
output terminal and the grounding. When conducting insulation resistance test / withstand voltage test on
these lines, please follow the conditions as described below.
Also, insulation resistance test / withstand voltage test cannot be conducted on sensor connection
terminals.
Insulation resistance test
●
・Between the power supply line and the grounding: 00MΩ/00VDC
・Between the power supply line and the input / output terminal: 0MΩ/00VDC
・Between the input / output terminal and the grounding: 0MΩ/00VDC
Withstand voltage test
●
・AC power specification: between the power and the grounding: AC 00V (for minute),
leak current: mA or less
・DC power specification: between the power and the grounding: AC 000V (for minute),
leak current: mA or less
Rated voltage /
allowable current
(at 0℃ )
L / N
00V or more
A or more
(Earth)
00V or more
0.A or more
Recommendation
Cross-sectional area
.sq to .0sq
AWG to
0.7sq to .0sq
AWG to
0.7sq AWG
Crimp terminal
Ring type .mm or less
For M
Ring type .mm or less
For M.