Wiring Instructions; Terminal Box Cover Removal - Oval ALTI mass Series Instructions Manual

6. WIRING INSTRUCTIONS

6.1 Terminal Box Cover Removal

Cable entrance of the transmitter is located on the
bot tom of the sensor unit. Remove the cover for
respective wiring connections.
() Using a flat tool, loosen the terminal box cover by
slowly turning it clockwise and hand rotate it further
until it comes off.
() Removing the c over provides ac c ess to the
terminal block.
() Reverse step of () shall be taken for re-tightening
the cover.
CAUTION:
Internal wiring could break if physical orientation
of terminal box is changed with rough handling.
If you desire to change the physical orientation,
consult OVAL sales office or nearest representative
in advance.
Terminal Box
Turn
Terminal Cover
A Flat Tool (that will not
scratch the painting)
Fig. .
L-770HP--E
7