Terminals - ILLKO REVEXmax S User Manual

REVEXmax - User's Manual
Features and highlights:
test results can be saved under an ID number which is unequivocally assigned
to the respective DUT (barcode)
the test structures created at the PC software can be loaded into the REVEX-
max
measurement data saved to the test instrument can be imported to PC software
via the USB port and reports can be generated
user-defined test sequences created at the PC software
user-defined report templates created at the PC software
2.2

Terminals

1. Test Socket for connection of tested appliance's power supply cord
2. Voltmeter [ ] - external voltage test terminal (WELD variant only)
3. Voltmeter [+] - external voltage test terminal (WELD variant only)
4. PE – terminal for connecting the exposed conductive part of the tested appli-
ance (the terminal is connected to the PE terminal of Test Socket 1)
5. I – touch leakage current test terminal
TOUCH
6. R / I
ISO ALT
7. R – earth bond test terminal
PE
8. EXT input - current clamp / three-phase adapter / other adapters connector
9. Fuse F 16 A / 500 V
10. USB - socket type A for connection USB 2.0 Full Speed HID (Human Interface
Device), e.g. barcode scanner
11. USB – socket type B, PC connection
12. Power supply cord
WARNING
Do not connect any external voltage to any terminal or connector.
The only exception is the power supply cord 12 which is intended
for powering the REVEXmax from the 230 V / 50 Hz mains
outlet.
Max. load on Test Socket 1 is 16 A (limited in time).
Use original accessories only.
Do not connect any external voltage between R
the PE in Test Socket 1 or PE terminal.
c 2019 ILLKO, s.r.o.
– insulation resistance / alternative leakage current test terminal
www.illko.cz
2 Description of the instrument
terminal and
PE
Page 10