Table of Contents
Advertisement
REVEXmax - User's Manual
5
Database operations
5.1
Storing measurement data
A set of data can be stored for each appliance. Data can be created and transferred
to the REVEXmax from a PC and other data is created during the measurement.
Each set of data (file) has its unique identification number (ID) assigned.
The structure of the file:
Item
Transfer from PC
ID
yes
test sequence
yes
measurement
no
data
final
no
evaluation
date of
no
measurement
5.2
The structure of the data memory
Measured values and other possible data are stored as a file in a temporary memory
where the ID is assigned and finally the file is transferred to the main memory.
Conversely you can load a set of measurements of a particular appliance from the
main memory to the temporary memory and then edit it.
Measuring up to 16 000 DUTs can be stored in the main memory.
To perform the whole procedure:
Read the device ID number (use the barcode scanner, RFID reader) or enter
the ID from the keyboard.
Perform all required measurements.
Check the visual inspection, functional test and measured values (PASSED
is preset by default).
Press the [save] key, the data will be transferred from the temporary memory
to main memory.
c 2019 ILLKO, s.r.o.
Description
1-20 ASCII
code charts
sequence
of test steps
editable on
a PC only
www.illko.cz
5 Database operations
Created
barcode scanner,
ID editor
transfer from PC,
assign of the test sequence
measurement and store
of the value
initial evaluation (passed) is
possible to change manually
saving the measured value
Page 35
Advertisement
Table of Contents
