Assigning A Test Sequence To Appliance; Using The Test Sequence - ILLKO REVEXmax S User Manual

REVEXmax - User's Manual
Some measurements cannot be measured separately (e.g. IEq, Uline
and S, etc.). If are these variables are independently selected, mea-
surement is performed at the same time.
5.6.3

Assigning a test sequence to appliance

In order to use the automatic procedure, is necessary to activate it. The automatic
measurement procedure can be activated in the following ways:
An automatic process is transferred from the PC individually for a particular
appliance, at the same time as the file's data. The test sequence is automati-
cally activated before starting the measurement.
If the file does not contain the loaded data for an test sequence, the appliance
can assign any of the procedures stored on the REVEXmax (see chapter 6.3).
5.6.4

Using the test sequence

If the tested appliances are assigned to the automatic measurement procedure, it is
possible to start a test of the appliance using the following procedure:
Confirm the Sequence wizard measurements using the [TEST] key. If you
press the [esc] key, the automatic procedure will be shut down and the mea-
surement can be done without using the test sequence.
Follow the instruction shown on the display or select the result of the evalua-
tion.
If you want to repeat a step, press the [Repeat] key. If the step was performed
successfully and you wish to proceed, press [TEST].
If you want to interrupt the automatic process and switch to the manual mode,
press the [End] key. The steps which have been performed up to now will be
retained.
During the test sequence procedure, it is not possible to store the measured
values with the [save] key. The results are stored after confirmation that the
procedure is completed.
c 2019 ILLKO, s.r.o.
www.illko.cz
5 Database operations
Page 41