Performance Revexmax; Applied Standards - ILLKO REVEXmax S User Manual

REVEXmax - User's Manual
WARNING
It is necessary to respect all safety regulations applicable to the
particular measurement.
Test Socket 1 of the REVEXmax must not be used for contin-
uously powering the appliance. It is intended for test purposes
only; max. test duration is 25 min @ 12 A and 60 s @ 12 16 A.
The functional test may only be performed after the DUT has
successfully passed the safety test.
Dangerous voltage or mains voltage may be present on Test
Socket 1 during some tests.
Devices under test which are connected to Test Socket 1 of the
REVEXmax can be powered by mains voltage during some tests.
The appliance can thus be activated.
The PE terminal is connected to the PE terminal of Test Socket
1. When using the REVEXmax, do not connect any voltage to
the terminal PE. If connected, there is a danger of electric shock
or damage to the REVEXmax.
Use only standard or optional accessories supplied with the
REVEXmax by your distributor.
The figures in this manual are only illustrative and may vary slightly
from the actual state or the version on your instrument.
1.2

Performance REVEXmax

The REVEXmax S (STANDARD) / REVEXmax W (WELD) is a professional,
compact, portable analyzer, designed to verify the electrical safety of appliances or
arc welding equipments (WELD variant only). The REVEXmax has an extraordi-
nary wide scope of use thanks to a lot of optional accessories, which enable testing
practically any portable or hard-wired, one-phase or three-phase appliance.
1.3

Applied standards

EMC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . EN 55011:2009+A1:2010
c 2019 ILLKO, s.r.o.
EN 61000-4-3:2006+A1:2007+A2:2010
www.illko.cz
1 Introduction
EN 61326-1:2013
EN 61000-4-2:2009
EN 61000-4-4:2012
EN 61000-4-5:2014
EN 61000-4-6:2014
EN 61000-4-11:2004
EN 61000-3-2:2014
EN 61000-3-3:2013
Page 7