Why Is The Video Recorder Notifying Ip Conflict; Why Is Image Getting Stuck When The Video Recorder Is Playing Back By Single Or Multi-Channel Cameras; Why Does My Video Recorder Make A Beeping Sound After Booting; Why Is There No Recorded Video After Setting The Motion Detection - HIKVISION DS-7100NI-K1/W/M Series User Manual

Solution
When adding camera, click Custom Add to add camera.

11.2.9 Why is the video recorder notifying IP conflict?

Reason
The video recorder uses the same IP address as other devices.
Solution
Change the IP address of video recorder. Ensure it is not the same as other devices.
11.2.10 Why is image getting stuck when the video recorder is playing
back by single or multi-channel cameras?
Reason
HDD read/write exception.
Solution
Export the video, and play it with other devices. If it plays normally on other device, change your
HDD, and try again.
11.2.11 Why does my video recorder make a beeping sound after
booting?
Reason
1. The front panel is not fastened (for the device which its front panel is removable).
2. HDD error, or do not have HDD.
Solution
1. If it makes continuous beeps, and your device's front panel is removable, ensure the front
panel is fastened.
2. If it makes non-continuous beeps (3 long, 2 short), take HDD error as an example, check if the
device has installed HDD. If not, you can go to System → Event → Normal Event → Exception,
and uncheck Event Hint Configuration to disable HDD error event hint.
Check if the HDD is initialized. If not, go to Storage > Storage Device to initialize the HDD.
Check if the HDD is broken. You can change it, and try again.
11.2.12 Why is there no recorded video after setting the motion
Network Video Recorder User Manual
122