Agilent Technologies 1100 Series System Manual page 56

3 Capillaries and Fittings
Item Fitting
*
descriptions see type
list below)
see description A/A
1 below
see description B/C
2
13 B/C
14 (micro ALS) B/B
14 (micro WPS) B/B
see description B/C
3
see description C/B
4
see description A/A
5
11 A/A
* see Table 14 on page 52
† SST: Stainless steel
* * PFS: Peek coated fused silica
Descriptions 1 The capillary G1375-87400 connects the mixer and the manual purge valve.
2 The capillary G1375-87318 connects the manual purge valve and the injection valve (port1).
to Table 10
3 The capillary G1375-87312 connects the injection valve (port 6) and the heat exchanger
4 The capillary G1375-87306 connects between the injection valve (port 6) and the heat
5 The capillary G1316-87300 connects between the heat exchanger (OUT) and the column.
The pressure drops in
NOTE
of
1000 µl/min.
Table 11 Specific capillaries for use with a micro CSV and a 20 µl flow sensor
46 1100 Series Capillary LC System Manual
Diameter Length
(µm) (mm)
170 280
125 550
100 200
250 1800
250 1800
100 200
100 550
170 70
170 380
(IN).
exchanger ( IN) if the thermostat G1330A/B is installed.
Table 10
Material Volume
(µl)
SST † 6.4
PFS** 6.8
PFS 1.6
SST 88
SST 88
PFS 1.6
PFS 4.4
SST 1.6
SST 8.6
are calculated for water (viscosity 1) and for a flow rate
Pressure Part number
drop (Bar)
2 G1375-87400
15 G1375-87318
13 G1375-87312
3 G1329-87302
3 G1377-87300
13 G1375-87312
37 G1375-87306
<1 G1316-87300
3 G1315-87311