Install The Diode Array Detector (Dad) (G1315B) - Agilent Technologies 1100 Series System Manual

7 Connect the free end of sampler-to-column capillary (G1375-87304) to the inlet of
Avoid excessive bending. See

Install the Diode Array Detector (DAD) (G1315B)

Connect the power cable to power only after you have finished the hardware
WARNING
installation of all modules in the stack.
1 Ensure the line power switch at the front of the diode array detector DAD is off.
2 If the system is to be connected to the user interface by LAN, install the JetDirect
3 Place the DAD on top of the TCC. Make sure that the two modules are interlocked
4 Connect one end of the LAN cross over cable (5183-4649) to the connector on the
5 Connect the free end of CAN-bus cable (5181-1516) from the TCC to one of the
6 Connect the power cable to the power socket at the rear of the DAD. Do not connect
7 Install the DAD flow cell (G1314-68714).
8 Route the DAD flow cell outlet capillary (G1315-68708) to an appropriate waste
9 Connect The DAD flow cell inlet capillary (G1315-68703) to the outlet of the
Ccarefully route all capillaries so that they are not crushed or broken by module front covers. Avoid excessive bending. See chapter 2 for advice on handling capillaries.
1100 Series Capillary LC System Manual
the analytical column in the TCC.
are not crushed or broken by module front covers.
card into the DAD. See Replacing the Interface Board in the DAD Reference
Manual.
correctly.
JetDirect card. Connect the other end of the LAN cross over cable to the
Chemstation.
CAN connectors at the rear of the DAD.
the power cable to power until you have finished the hardware installation of all
modules in the stack.
container.
analytical column.
17
Installing your Capillary LC System 1
NOTE
Carefully route all capillaries so that they
Chapter 2 for advice on handling capillaries.