ATEQ F620 Quick Start Manual page 39

TO START SPECIAL CYCLES...
1. On the SPECIAL CYCLE MENU screen, select a
cycle, and press to validate.
2. Press Start to start the cycle.
3. To stop the current cycle press Reset
PARAMETERS menu
Use this menu to configure the measurement cycle associated to each test program.
PARAM / Pr 001
TYPE : LEAK TEST
COUPL. A
FILL TIME
STAB TIME
TEST TIME
DUMP TIME
Press. UNIT
Max FILL
Default parameters of the LEAK type tests
Label Parameter
COUPL. A or COUPL. B Coupling time
FILL TIME Fill time
STAB TIME
Stabilization time
TEST TIME Test time
DUMP TIME Dump time
Press. UNIT Pressure units
Max FILL Maximum fill pressure
Min FILL
Minimum fill pressure
LeakUnit Reject unit
Test FAIL Test fail
Ref. FAIL
Reference fail
FUNCTIONS Functions
Some parameters are displayed when specific functions are activated.
Label Parameter
INTER-CYCLE Inter cycle time
Max PreFILL
Max pre fill pressure
OFFSET Leak offset
PRE DUMP Pre dump time
QSG_F620.283.00_EN_01 / 2019-02-20
.
0.0 s
2.0 s
2.0 s
2.0 s
1.0 s
bar
5.00
Description
Required times when instrument manage
automatic jigs
Time to pressurise the part under test
Time to stabilise the pressure on the test and
reference parts
Time for leak measurement
Time to vent the part to atmosphere
Pressure unit (bar, mbar, PSI, Pa, kPa, MPa)
Maximum level of the fill pressure
Minimum level of the fill pressure
Measurement units
Upper leak rate limit for the test part. Above this
limit, the part is considered as defective.
Reference part reject level
Access to additional functions
Description
Time between two automatically chained
programs (Sequence function)
Maximum level of the pre fill pressure (Pre fill
function)
Leak offset value
Time to dump the part under test (Pre fill
function)
39 / 46