Modifying A Parameter - ATEQ F620 Quick Start Manual

CONFIGURING THE ASSOCIATED MEASUREMENTS
3. Select a measurement type and press
The parameters of the selected measurement type are
36 / 46
displayed.
4. Define the measurement cycle parameters.
See: Modifying a parameter.

MODIFYING A PARAMETER

Use this procedure to complete the test program setup.
The protection of the parameters is configurable. If the icon
the screen, you must insert the USB unlocking device or enter a password before modifying
a parameter.
On the PARAMETERS screen of the program (see: Preparing a program):
1. Press up/down
modify, and press
An arrow
being modified.
2. Use the up/down
to modify the parameter value, and press
validate.
The arrow
3. Repeat these steps until all parameters are set.
4. To return to the MAIN MENU screen, press Esc
as many times as necessary.
QSG_F620.283.00_EN_01 / 2019-02-20
to select the parameter to
.
is displayed on the right of the parameter
up/down
returns to the left of the modified parameter.
.
PARAM / Pr 001
TYPE : LEAK TEST
COUPL. A
FILL TIME
STAB TIME
TEST TIME
DUMP TIME
Press. UNIT
Max FILL
is displayed at the bottom of
PARAM / Pr 001
TYPE : LEAK TEST
COUPL. A
FILL TIME
STAB TIME
TEST TIME
DUMP TIME
Press. UNIT
Max FILL
PARAM / Pr 001
TYPE : LEAK TEST
COUPL. A
FILL TIME
STAB TIME
TEST TIME
DUMP TIME
Press. UNIT
Max FILL
keys
to
PARAM / Pr 001
TYPE : LEAK TEST
COUPL. A
FILL TIME
STAB TIME
TEST TIME
DUMP TIME
Press. UNIT
Max FILL
0.0 s
2.0 s
2.0 s
2.0 s
1.0 s
bar
5.00
0.0 s
2.0 s
2.0 s
2.0 s
1.0 s
bar
5.00
0.0 s
2.0 s
2.0 s
2.0 s
1.0 s
bar
5.00
0.0 s
2.0 s
2.0 s
1.0 s
1.0 s
bar
5.00