Motor And Feedback Specifications; Table 3-4: Feedback Specifications - Aerotech ANT130LZ-035 Hardware Manual

Electrical Specifications and Installation

3.3. Motor and Feedback Specifications

Table 3-4: Feedback Specifications
Hall-Effect Sensors Specifications
Supply Voltage
Supply Current
Output Type
Output Voltage
Output Current
Thermistor Specifications
Polarity
Cold Resistance
Hot Resistance
Note: 1K pull-up to +5V recommended.
Encoder Specifications
Supply Voltage
Supply Current
Output Signals
Limit Switch Specifications
Supply Voltage
Supply Current
Output Type
Output Voltage
Output Current
Output Polarity
Notes:
If the ANT130LZ is driven beyond the electrical limit, it will encounter a mechanical stop. Impacting the mechanical stop could
l
cause damage to the stage even at low speeds.
26
5 V ±5%
50 mA
Open Collector
24 V max (pull up)
5 mA (sinking)
Logic "0" (no fault)
Logic "1" (over-temperature fault)
∼100 Ω
∼10 K
5 V ±5%
250 mA
Sinusoidal Type (Incremental Encoder): 1 V
signals SIN+, SIN-, COS+, COS- are .5 V
5 V ±5%
25 mA
Open Collector
5 V
10 mA (sinking)
Normally Closed (NC)
Sinks current to ground (Logic "0") when not in limit
l
High impedance (Logic "1") when in limit
l
Requires external pull-up to +5 V (10 kΩ recommended)
l
Chapter 3
ANT130LZ Hardware Manual
into 120 Ω Load (differential
pk-pk
relative to ground.)
pk-pk
www.aerotech.com