Chapter 3: Electrical Specifications And Installation - Aerotech ANT130LZ-035 Hardware Manual

Hide thumbs Also See for ANT130LZ-035:
Table of Contents

Advertisement

ANT130LZ Hardware Manual

Chapter 3: Electrical Specifications and Installation

W A R N I N G : Electrical installation must be performed by properly qualified personnel.
Aerotech motion control systems are adjusted at the factory for optimum performance. When the ANT130LZ
is part of a complete Aerotech motion control system, setup usually involves connecting the ANT130LZ to
the appropriate drive chassis with the cables provided. Labels on the system components usually indicate
the appropriate connections.
If system level integration was purchased, an electrical drawing showing system interconnects has been
supplied with the system (separate from this documentation).
The electrical wiring from the motor and encoder are integrated at the factory. Refer to the sections that
follow for standard motor wiring and connector pinouts.
D A N G E R :  Remove power before connecting or disconnecting electrical components or
cables. Failure to do so may cause electric shock or damage to the equipment.
W A R N I N G : Operator access to the base and tabletop must be restricted while connected to
a power source. Failure to do so may cause electric shock.
N O T E : Refer to the controller documentation to adjust servo gains for optimum velocity and position
stability.
www.aerotech.com
Electrical Specifications and Installation
Chapter 3
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ant130lz seriesAnt seriesAnt130lz-060

Table of Contents