Connecting The Modem - Paradyne FrameSaver SLV 9128 Installation Instructions Manual

Connecting the Modem

1. Insert the RJ11C connector on the modem cable into the Modem/MDM interface.
2. Insert the other end of the cable into the phone service RJ11C jack.
P
O
R
T
1
POWER
3. Verify modem operation.
If Port Use is set to Terminal (dial-in access):
– Dial the modem's phone number using a remote asynchronous terminal or PC.
– Verify that the Main Menu appears.
If Port Use is set to Net Link (SNMP, Telnet, FTP, and trap dial-out):
– Dial the modem's phone number using a PC running PPP or SLIP link protocol.
– From the PC, run an IP Ping test to the modem interface.
If your results using either method are unsuccessful, make sure both ends of the
modem cable are properly seated and secured. Then, verify that the modem was
configured correctly (see Setting Up the Modem on page 13). Otherwise, refer to
the status information in Operation and Maintenance of the User's Guide.
Proceed to Connecting to the ISDN on page 22 if the FrameSaver unit is equipped with
a DBM.
P
O
R
T
2
COM DSX
MODEM DBM NET
ENET
21
RJ11C
Jack
00-16846