Paradyne FrameSaver SLV 9128 Installation Instructions Manual page 22

Connecting to the ISDN
This procedure only applies to a FrameSaver unit equipped with an ISDN DBM.
1. Insert the 8-pin connector on the ISDN cable into the DBM interface.
2. Insert the other end of the cable into the ISDN service jack.
– RJ49C for a FrameSaver unit with BRI DBM.
– RJ48C for a FrameSaver unit with PRI DBM.
3. Setup the unit at the other end of the ISDN circuit.
P
O
R
T
1
POWER
4. Verify the ISDN line by checking the DBM Interface Status.
Main Menu
Line Status should be Active. If an invalid ( Inv) status (e.g., Inv SPID for a BRI
DBM) is displayed, verify that you entered ISDN physical options correctly.
P
O
R
T
2
COM
DSX
Status DBM Interface Status
MODEM DBM NET
ENET
22
RJ49C or
RJ48C
Jack
00-16847