Connecting To Power - Paradyne FrameServer SLV 9520-ILM Installation Instructions Manual

Connecting to Power

The FrameSaver SLV 9520-ILM is powered by redundant power modules. Each is
supplied with a power cable.
Procedure
To install the power cable:
1. Verify that the switch on the power module is in the Off (0) position.
2. Push the 3-hole connector of the power cable into the power receptacle on the back
of the FrameSaver SLV 9520-ILM. Fix the cable to the rail with a cable tie or other
strain relief device.
3. Connect the other end of the power cable to a grounded 110 Vac power source.
4. Push the switch on the power module to the On (1) position.
110 Vac
UPS
110 Vac
If two power modules are used, connect them if possible to separate power sources. If
one power source fails, the FrameSaver SLV 9520-ILM continues to run.
L A
N
98-16033
7