Setting Up The Isdn Dbm - Paradyne FrameSaver SLV 9128 Installation Instructions Manual

Setting Up the ISDN DBM

FrameSaver SLV 9128s and 9128-IIs may be equipped with an ISDN PRI or BRI DBM.
These instructions are for units with ISDN backup capability.
The following guidelines apply:
Central site configuration guidelines:
– Set up the ISDN DBM physical interface.
– If a BRI DBM, change the Automatic Backup Configuration to
Multi_Site_Backup. (A PRI DBM is already configured for multisite backup.)
– Modify the Link Profile(s) that Automatic Backup Configuration created to add a
phone number.
Remote site configuration guidelines:
– Set up the ISDN DBM physical interface.
– If a PRI DBM, change the Automatic Backup Configuration to
Single_Site_Backup. (A BRI DBM is already configured for single-site backup.)
– Modify the HQ_Site Link Profile that Automatic Backup Configuration created to
add a phone number.
– Set the criteria by which automatic backup will take place.
Setting Up the DBM Physical Interface
1. Configure the DBM interface.
Main Menu
2. Minimally, set the following configuration options:
– Interface Status is set to Enable.
– Local Phone Number 1 is entered, plus the following:
FrameSaver Unit with BRI
Configure the B-channels:
Service Profile ID1 (SPID)
Service Profile ID2 (SPID)
Local Phone Number 2
3. Save the configuration and return to the ISDN menu.
Configuration ISDN Physical
FrameSaver Unit with PRI
Configure T1 physical characteristics
to match the service provider's
settings.
14