About The Installation Procedures; Full Installation And Setup - Paradyne FrameSaver SLV 9128 Installation Instructions Manual

About the Installation Procedures

There are two methods for installing and setting up the FrameSaver unit.
One person can install and set up the unit. If this is the case, see Full Installation
and Setup .
An installer can physically install and set up access to the unit, and the network
operation center (NOC) can complete the setup. If this is the case, see Minimal
Installation for Service Providers on page 9.
Certain procedures are common to both the full installation and minimal methods.
These procedures are referenced in the full and minimal installation instructions
(starting with Setting Up Local Management at the Central Site on page 12). Refer
to them, as needed.

Full Installation and Setup

An Easy Install screen is provided to simplify installation and setup. It can be used
for the first part of the installation when one person is installing and setting up the unit
from beginning to end.
Easy Install Screen Example *
main/easy_install
Device Name: Node A
Service Type:
Node IP Address:
Node Subnet Mask:
TS Access: DLCI
Create a Dedicated Network Management Link
Ethernet Port Options Screen
Time Slot Assignment Screen
Network 1 Line Framing Format:
Network 1 Line Build Out (LBO):
Network 1 Line Coding Format:
DS0 Base Rate (Kbps):
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Ctrl-a to access these functions, ESC for previous menu
Save
* The Service Type and Ethernet Port Options Screen only applies to the
Model 9128-II. DS0 Base Rate (Kbps) only applies to the Model 9128.
EASY INSTALL
Frame Relay
000.000.000.000 Clear
000.000.000.000 Clear
980
ESF
0.0
B8ZS
Nx64
6
9128-II
5/26/2000 23:32
MainMenu Exit