Connecting To The Ethernet; Verifying That Data Is Being Received - Paradyne FrameSaver SLV 9128 Installation Instructions Manual

Connecting to the Ethernet

This procedure only applies to a FrameSaver SLV 9128-II.
1. Insert one 8-pin connector of the Ethernet cable into the Ethernet port.
2. Insert the other end of the cable into the Ethernet interface of the LAN where the
NMS resides.
P
O
R
T
1
POWER
3. Check Health and Status messages in the left column of the System and Test
Status screen to verify that there are no Ethernet-related Health and Status
messages.
Main Menu
If the Ethernet Link Down message appears, make sure both ends of the
Ethernet cable are properly seated.

Verifying That Data is Being Received

1. Return to the Main Menu and select Status.
2. Select Performance Statistics, and select an interface's frame relay statistics
(e.g., Network Frame Relay).
Main Menu
3. Clear the statistics and see whether the counts for Frames Received and
Characters Received under the Frame Relay Link are incrementing, and verify that
there are no errors under the Frame Relay LMI statistics. Refresh the screen to
update the counts.
– If data is being received, the count increments after refreshing the screen.
– If data is not being received, recheck the cable connections, and replace or
repair a damaged cable. Recheck LMI status; you may need to contact your
service provider. Next, check the DLCI's status.
P
O
R
T
2
MODEM
COM
DSX
Status System and Test Status
Status Performance Statistics
DBM NET
ENET
00-16847
Network Frame Relay
23
NMS
LAN