Setting Up The Modem - Paradyne FrameSaver SLV 9128 Installation Instructions Manual

Setting Up the Modem

The unit has an integral modem for remote management. It is already set up for dial-in
access to the unit, with Port Use set to Terminal.
If using the modem for dialed IP network connectivity (SNMP, Telnet, FTP, or
trap dial-out):
1. Select Modem Port.
Configuration
2. Minimally, change Port Use to Net Link, and assign the interface's IP Address and
Subnet Mask if it is different from the Node's. Change Link Protocol to SLIP, if
necessary (PPP is the default setting).
3. Save the configuration.
Setting Up Call Directories if Trap Dial-Out Is Desired
1. Set up directory phone numbers.
Main Menu
2. Select Directory Number A (for Alarm).
3. Enter the phone number(s). Valid characters include:
– ASCII text
– B for blind dialing
– W for wait for dial tone
– P for pulse dialing unless B specified
– T for tone dialing unless B specified
– Space, underscore ( _ ), comma ( , ) for a 2-second pause, and dash (–)
readability characters
4. Save the phone number(s).
Setting Up to Use the Modem PassThru Feature
The Modem PassThru feature allows access to the router via a dial-up connection to
the unit. When this feature is set up and active, a logical connection between the unit's
modem and COM ports is made, and data received over the modem port is transmitted
out the COM port to the router's auxiliary (AUX) serial port. When an escape sequence
(minus, minus, minus) is detected, the FrameSaver unit switches back to normal user
interface operation. If this feature will be used, the COM port must be configured for
that use.
1. Configure the COM port to use Modem PassThru.
Main Menu
Communication Port
2. Set Port Use to Modem PassThru.
3. Save the configuration.
Management and Communication
Control Modem Call Directories
Configuration Management and Communication
13
Modem Port