Safety Instructions; Installing The Power Supply And Cord - Paradyne FrameSaver SLV 9128 Installation Instructions Manual

Safety Instructions

Read the Important Safety Instructions beginning on page 25.

Installing the Power Supply and Cord

1. Insert the power supply's 4-prong plug into the POWER jack.
When inserting the plug at the rear of the FrameSaver unit, align the plug with the
notch above the POWER jack. Make sure the locking tab snaps securely into the
jack.
2.
Locking
Tab on
Top
3.
4. Plug the power cord into the grounded power outlet and check the LEDs.
If any LEDs light, you have power. If not, refer to Troubleshooting in the User's
Guide for possible explanations.
NOTE:
The rear panels shown in these instructions are for the Model 9128-II, which has
an Ethernet port. Except where noted, installation instructions are the same for the
Model 9128 without an Ethernet port.
P
O
R
T
1
POWER
P
O
R
T
1
COM
POWER
P
O
R
T
2
MODEM DBM NET
ENET
DSX
3
2. Insert the 3-prong plug
into an AC outlet.
Power Cord /
Transformer
3.
The front panel
OK LED lights.
3-Prong
Grounded
AC Outlet
00-16841