Configuring Snmp Trap Managers And Trap Dial-Out - Paradyne FrameSaver SLV 9128 Installation Instructions Manual

Setting the Criteria for Automatic Backup
1. Enable Auto Backup.
Main Menu
When a failure occurs, the unit automatically enables the Alternate Link and traffic
is rerouted over the backup (alternate) interface.
2. Specify When Auto Backup Allowed – Always or Restrict. If Restrict is selected,
specify the days and hours of the week during which automatic backup can take
place.
3. Save the configuration.

Configuring SNMP Trap Managers and Trap Dial-Out

Once the FrameSaver unit is connected to the network, SNMP trap managers, SNMP
traps, and trap dial-out can be configured.
1. Select SNMP Traps.
Main Menu
SNMP Traps
2. Configure the following:
– Enable SNMP Traps.
– Identify the total Number of Trap Managers.
– Specify the IP address of the NMS(s) to which traps will be sent.
– Specify the network Destination for the Trap Manager(s).
– Select desired trap categories.
– Enable Trap Dial-Out, if desired.
3. Save the configuration.
4. Return to the Main Menu.
Configuration Auto Backup Criteria
Configuration Management and Communication
16