Connecting To The Network - Paradyne FrameSaver SLV 9128 Installation Instructions Manual

Connecting to the Network

1. Insert the 8-pin connector of the RJ48C network cable into the network interface.
2. Insert the other end of the cable into the RJ48C modular jack.
P
O
R
T
1
POWER
NOTE:
After connecting the network cable, wait a few minutes to allow
Auto-Configuration a chance to discover the frame relay characteristics
and DLCIs.
3. Verify that the Network signal (SIG) LED is green, and that the Network
out-of-frame (OOF) and alarm (ALM) LEDs are off. If so, the network interface is
set up correctly and is operational. If not, make sure both ends of the network
cable are properly seated.
The FrameSaver SLV 9128-II has a FR (Frame Relay) LED. It will be green when
the unit is operating in Frame Relay mode and LMI is up, yellow when the unit is
operating in Frame Relay mode and LMI is down, and it will be off when the unit is
operating in Leased Line mode.
4. Check Health and Status messages in the left column of the System and Test
Status screen.
Main Menu
If LMI Down, Network appears for more than three minutes, or any other
network-related status message appears, refer to the status information in
Operation and Maintenance of the User's Guide for possible reasons for the
messages and what can be done to resolve the problem.
If the unit does not have ISDN backup capability, proceed to Configuring SNMP Trap
Managers and Trap Dial-Out on page 16.
P
O
R
T
2
COM DSX
Status System and Test Status
MODEM DBM NET
ENET
17
RJ48C
Jack
00-16843