Minimal Installation For Service Providers - Paradyne FrameSaver SLV 9128 Installation Instructions Manual

Minimal Installation for Service Providers

In the following procedures, once the unit is installed and minimal configuration is
completed using the Easy Install feature, the NOC can complete and verify the setup.
For a Model 9128-II, see Installing and Setting Up a Model 9128-II in Leased Line
Mode on page 10 to install and set up the unit in Leased Line mode.
Physically Installing the Unit and Setting Up for Remote Access
It is assumed that frame relay service is turned on at the site. For a FrameSaver SLV
9128-II, this procedure is for setting up the unit in Frame Relay mode; the FrameSaver
SLV 9128 is always in Frame Relay mode.
1. Follow Steps 1 through 8 of Full Installation and Setup on page 7.
2. If the DSX-1 interface will be used, install the DSX-1 cable (see Connecting to the
DSX on page 19).
3. Install the DTE cables (see Connecting to the DTE (Router or FRAD) on page 20).
4. Install the modem cable (see Connecting the Modem on page 21).
5. If the unit is equipped with an ISDN DBM, install the ISDN DBM cable (see
Connecting to the ISDN on page 22).
6. If a FrameSaver SLV 9128-II will use its Ethernet port for management, install the
Ethernet cable (see Connecting to the Ethernet on page 23).
Physical installation of the unit is complete; the NOC can now remotely access the unit
for additional configuration.
9