Removing The Projector Lens - Christie 4K10-HS Installation And Setup Manual

Calibrate the lens motors when any of the following conditions are met:
• After a lens change.
• After the projector is moved.
• After any manual adjustment made to the zoom or focus.
To calibrate the lens motor:
1. Press MENU on the remote control or built-in keypad.
2. Select Configuration > Lens Settings > Lens Calibration.
3. Press ENTER.
4. To start the lens calibration, select OK.

Removing the projector lens

To safely remove the projection lens, complete the following steps.
1. Center the lens while the projector is switched on by pressing the LENS H or LENS V button
and then pressing ENTER.
Ensure the lens is at or near its center position. Attempting to remove the lens with a large
offset may cause damage to the lens assembly.
2. Turn off the projector.
3. Allow the projector to cool down into standby mode before replacing the lens.
4. After the projector has cooled down and prior to replacing the lens, remove the power cord.
5. Push in and hold the lens release button.
6. Turn the lens counterclockwise by a quarter to release the lens.
7. Gently pull the lens out of the lens holder.
Christie recommends covering the lens opening with the dust cover to prevent damage to
the projector.
4K7-HS/4K10-HS Installation and Setup Guide
020-001449-02 Rev. 1 (06-2019)
Copyright ©2019 Christie Digital Systems USA Inc. All rights reserved.
Installation and setup
23