Setting Up The Projector Lens; Adjusting The Zoom And Focus; Adjusting Lens Position; Resetting The Lens To Home Position - Christie Inspire Series Installation And Setup Manual

Setting up the projector lens

Set up the projector lens to adjust the image size, focus, and position.

Adjusting the zoom and focus

Ensure that the image reflected from the digital micromirror device (DMD) is parallel and centered
with the lens and screen.
1. Display an image or test pattern that can be used to analyze image focus and geometry.
2. Press ZOOM on keypad or remote control.
You can also select Menu > Configuration > Lens Settings > Zoom.
3. Use the up and down arrow keys to zoom in or out of the image.
4. To exit the menu, press EXIT.
5. Press FOCUS on keypad or remote control.
You can also select Menu > Configuration > Lens Settings > Focus.
6. Use the up and down arrow keys to adjust the focus of the image.
7. To exit the menu, press EXIT.
8. To refine your adjusts, repeat steps 2 to 7.

Adjusting lens position

Shift the lens to the specific position.
1. Display an image or test pattern that can be used to analyze image location.
2. Press LENS SHIFT (up button) on keypad or LENS H/LENS V on remote control.
You can also select Menu > Configuration > Lens Settings > Lens Shift.
3. Use the arrow keys to adjust the lens position.
For best lens performance, keep the shift values within the lens offset ranges. For more
information, refer to
4. To exit the menu, press EXIT.

Resetting the lens to home position

Set the lens offset back to the home position.
1. Press LENS on keypad or LENS H/LENS V on remote control.
You can also select Menu > Configuration > Lens Settings > Lens Calibration.
2. Press ENTER.
3. To start the lens calibration, select OK.
Inspire Series Installation and Setup Guide
020-001933-01 Rev. 1 (10-2021)
Copyright ©2021 Christie Digital Systems USA Inc. All rights reserved.
Calculating the lens offset
Installation and setup
on page 32.
28