FLIR GRASSHOPPER 3 Series Technical Reference page 19

To uninstall or reconfigure the driver at any time after setup is complete, use the DriverControlGUI (see
Camera Setup).
4. Configure IP Settings
After installation is complete, the GigE Configurator opens. This tool allows you to configure the IP settings of the
camera and network card.
If the GigE Configurator does not open automatically, open the tool from Start Menu>FlyCapture
SDK>Utilities>GigE Configurator. If prompted to enable GigE enumeration, select Yes.
a. In the left pane, select the Local Area Connection corresponding to the network interface card (NIC) to
which the camera is connected.
b. In the right pane, review maximum transmission unit (MTU). If not 9000, enable jumbo frames on the NIC
by clicking Open Network Connections. (While most NICs support 9000-byte jumbo frames, this feature
may be disabled by default.)
2/10/2017
©2013-2017
FLIR Integrated Imaging
Solutions Inc. All rights reserved.
Note: GigE Vision cameras on Linux systems use native Ubuntu
drivers.
Grasshopper
2 Grasshopper3 PGE Installation
®
3 PGE Technical Reference
Configuring
8