Writing To The Controller - Deif CGC 200 Operator's Manual

CGC 200 Operator's manual 4189340770
UK
● Reading information using the batch read function (
from the controller, then writes it to a .usw file on the PC.
● Backing up the controller: this writes the controller information to a .bak file on the PC.
Batch read function
The controller logs, input and output configuration, and parameter settings can be read and saved in a file on
the PC. To use the batch read function:
1. Click the batch read and write icon (
2. The Batch job (Reading) dialogue box opens. Select the information that you would like to read using the
check boxes and click Run.
3. A window opens. Browse to the location where you would like to save the file, type in the name, and click
Save
4. The parameters and input and output configuration may be changed, and written to the CGC 200. Alter-
natively, the parameters can be saved to a file on the PC. See Writing to the controller for more infor-
mation.

5.3.4 Writing to the controller

You can write to the controller by:
DEIF A/S
) (described below): this reads all the information
) on the toolbar and select Read from device.
Using the Utility Software
Page 38 of 43