Table of Contents
Advertisement
CGC 200 Operator's manual 4189340770
UK
●
Writing the parameter and input and output values as you change them. To do this, open the Parameter
page in List view. Double click on a parameter to open it. Change the parameter and click Write in the
parameter dialogue box.
●
Writing all the parameters in the utility software. Select Parameters, then Write (
the Parameters page, the write icon (
●
Writing information using the batch write function (
●
Restoring the controller information from a .bak file, using Restore Device.
Batch write function
If a CGC 200 file has been saved on the PC, it can be opened, edited and then written to one or more CGC
200s. To use the batch write function:
1. Click the batch read and write icon (
2. Select Write to device.
3. The Batch job (Writing) dialogue box opens.
Select the information that you would like to write and click Run.
5.3.5 Firmware upgrade
You can use the utility software to upgrade the firmware on the CGC 200.
To upgrade the firmware:
DEIF A/S
) is also available on the toolbar.
) (described below).
) on the toolbar.
Using the Utility Software
). When you are on
Page 39 of 43
Advertisement
Table of Contents
