Viewing Alarms; Resetting Alarms; Stopping The Genset; Adjusting And Testing The Display - Deif CGC 200 Operator's Manual

Compact genset controller

Hide thumbs Also See for CGC 200:

Table of Contents

CGC 200 Operator's manual 4189340770

Using the controller

3.2.4 Viewing alarms

The

LED flashes when there is an alarm condition. You can see which alarm is present by looking at

the icons on the display.

To reset the alarms if there is a shutdown alarm, press

To stop the genset:

1. Make sure that the genset is in Manual mode.

●

If the genset is in Auto mode, press

2. Press

The display light intensity can be adjusted by pressing

for more than five seconds. Keep pressing

until the light level (0 to 7) is right for you. 0 corresponds to the dimmest light, and 7 corresponds to the

brightest light.

You can test the LED lamps and display by pressing

for more than three seconds. If the LED lamps are

working correctly, these will all be lit. If the display is working correctly, it should look like the image below.

DEIF A/S

Page 13 of 43

Table of Contents