5
Adjustments
28
5.5
Adjusting the Belt Tension
Danger!
Risk of death via electric shock!
Before opening the housing cover, disconnect the device from the mains supply and wait at least one
minute until the power supply unit has discharged.
Figure 29
i
Notice!
The adjustment of all belt tension brackets can be done in the same manner.
1. Unplug the printer from the electrical outlet.
2. Remove the rear cover.
3. Adjusting the belt tension brackets :
•
Loosen 2 screws.
•
Swing the bracket so that the belt is tensioned tightly.
•
Tighten 2 screws.
4. Mount the rear cover.
Adjusting the belt tension
28