4
Replacing Assembly Units
4.6
Replacing the Label Sensor
i
Notice!
Soiling of the label sensor can also cause malfunctions.
Before replacing the label sensor, check whether it is soiled and clean it if necessary.
3.2 on page 7
Figure 13
Replacing the label sensor
Danger!
Risk of death via electric shock!
Before opening the housing cover, disconnect the device from the mains supply and wait at least one
minute until the power supply unit has discharged.
1. Unplug the printer from the electrical outlet and remove the rear cover.
2. Remove the material from the printer.
3. Disconnect the plug (2) of the cable (1) from the connector of the label sensor (3).
4. Loosen the screw (7) and pull the label sensor (3) with the spindle (5) and the blind (6) out of the profile (4).
5. Mount the new label sensor in the opposite order.
6. Mount the rear cover and restore all connections.
7. Adjust label sensor mechanically Operator's Manual.
8. Adjust label sensor electrically Configuration Manual.
1
2
3
4
3
5
15
6
7