Table of Contents
Advertisement
4
Replacing Assembly Units
Figure 4
Printhead replacement 2
5. Pull the printhead retainer (10) with the printhead out of the printer .
6. First disconnect the power cable (12), following the data cable (9).
7. Loosen 2 screws (13) and remove the printhead (16) from the printhead retainer (10).
13
14
10
15
16
Figure 5
Printhead replacement 3
Installing the printhead
1. Insert 2 screws (13) through the holes in the adjusting elements (14) and the printhead retainer (10) into the
drillings (15) of the new printhead (16).
2. Ensure the correct positioning of the printhead (16) at the printhead retainer (10) and tighten the screws (13).
3. First connect the data cable (9), following the power cable (12).
5. Push the printhead retainer (10) with the printhead onto spring (11).
6. Attach the printhead retainer (10) with the screw (8) on the printer.
7. Mount the antistatic brush (6).
8. Reload labels and transfer ribbon.
8
10
Figure 6
Printhead replacement 4
9
10
11
12
13
14
15
9
Advertisement
Table of Contents
