Configuring The Esp302 For Connection To A Corporate Network Using Dynamic Ip Configuration - Newport ESP302 Startup Manual

ESP302 Controller
A1270B1 - EDH0411En1021 – 02/20
3.7.3 Configuring the ESP302 for Connection to a Corporate Network Using Dynamic
IP Configuration
Setting HOST dynamic IP address through the front panel
• Connect the Ethernet cable to the HOST connector of the ESP302 controller and to
your network.
• Go to "Setting/Ethernet" tab.
• Tick "dynamic IP".
• Press "Set" to apply changes. This button turns to "Cancel (Searching)".
When complete, the IP address selected by your DHCP is displayed on the top of the
screen.
• In case the ESP302 cannot negotiate an IP address from the DHCP, the search can
be stopped by pressing "Cancel (Searching)". The IP address on the top of the screen
becomes "None". In that case contact your IT department.
It is recommended to ask your IT department to configure the ESP302 to your network
to avoid any issue with your network policies and rules.
20
Start-Up Manual