Configuring The Xps-Rl For Connection To A Corporate Network Using Dynamic Ip Configuration - Newport XPS-RL Quick Start Manual

XPS-RL
EDH0367En1021 — 12/17
A pop-up windows appears showing the "REBOOT IN PROGRESS". When the boot
sequence is complete, the user is redirected to the login page. The time to reboot is
about 50 seconds.
Connect the CAT-5 network cable (black) to the HOST connector of the XPS-RL
controller and to your network.
After restarting the controller, open the Internet browser and connect using your given
Static IP address.
If you don't want to connect directly to the Corporate Network using the Dynamic IP
Configuration, skip to Section 2.6: "Configuring the Controller".
2.5.5 Configuring the XPS-RL for Connection to a Corporate Network Using Dynamic
IP Configuration
It is recommended to ask your IT department to configure the XPS-RL to your network
to avoid any issue with your network policies and rules.
• Connect to the XPS-RL as described in Section 2.5.3: "Direct Connection to the
XPS-RL Controller".
• Connect the host plug to your network using a direct cable.
• Get to Controller → IP management web page
• Select dynamic IP as shown below:
It is needed to connected the controller to the network using the HOST plug before
Reboot. If not, the controller will wait for the network DHCP and a timeout will
happen.
NOTE
12
Quick Start