Connecting To The Esp302 Through Comm. Port; Connecting To The Esp302 Through Ethernet Port - Newport ESP302 Startup Manual

ESP302 Controller
A1270B1 - EDH0411En1021 – 02/20
3.6

Connecting to the ESP302 through COMM. port

This port allows for RS232 communication.
3.7

Connecting to the ESP302 through Ethernet port

ESP302 supports 10/100/1000 Mbps Ethernet networking and can be accessed through:
1. Direct connection PC-to-ESP302.
The Ethernet plugs "REMOTE" or "HOST" (with static IP) can either be used.
The plug "REMOTE" has a fixed IP address (192.168.254.254). The DHCP server
active on this plug will automatically configure the connected computer to make it
ready for communication with the ESP302 controller.
The "HOST" plug has an adjustable static IP address (192.168.0.254 upon delivery).
This plug requires the connected computer to be set to a compatible IP address
value.
2. Network connection.
The Ethernet plug identified "HOST" must be used (with static IP or dynamic IP) to
connect the ESP302 controller to a Network. Before connection, the controller IP
setting must be set by the Network administrator.
The following cable is provided with the motion controller.
This standard Ethernet straight through black cable can be used when either connecting
the device directly to a PC or to a standard network hub or switch.
Figure 14: Straight through cables.
14
Start-Up Manual