Newport ESP302 Startup Manual page 27

ESP302 Controller
Setting HOST static IP address through the website
Once you are logged in using the previously described steps with a direct connection,
you can change the IP configuration of the controller in order to connect the ESP302
over a Network.
• Get to Controller → IP management web page.
• Select Static IP configuration.
• Enter your IP address, Netmask and Gateway.
• The above shown addresses are only examples.
• Once the appropriate addresses for the Static IP configuration are set, click on
"SAVE CONFIGURATION" and the following screen appears:
• Click "OK" and reboot the controller by clicking REBOOT.
A pop-up window appears showing "REBOOT IN PROGRESS". When the boot
sequence is complete, the user is redirected to the login page. The time to reboot is
about 50 seconds.
Connecting to the ESP302
• Remove the REMOTE cable and connect your network to the HOST connector of
the ESP302 controller.
• If needed, configure your PC back to its original Ethernet configuration to access
your network.
• Open your internet browser and use the Static IP address.
If you don't want to connect to the Corporate Network using the Dynamic IP
Configuration, skip to section 3.8: "Connecting the Stages".
19
Start-Up Manual
A1270B1 - EDH0411En1021 – 02/20