Cross-Over Cables (Gray); Straight Through Cables (Black) - Newport XPS-D Startup Manual

XPS-D Controller
EDH0395En1031 – 09/18
The "HOST" plug has an adjustable IP address (192.168.0.254 upon delivery). This
plug require the connected computer to be set to a compatible IP address value.
2. Network connection.
The Ethernet plug identified "HOST" must be used to connect the XPS controller to
a Network. Before connection, the controller IP setting must be set by the Network
administrator.
The two following cables are provided with the motion controller.
3.5.1

Cross-Over Cables (Gray)

Standard Ethernet cross over cables are required when connecting the device directly to
the Ethernet port of a PC.
Cross-over cables are typically labeled (cross-over or XO) at one or both ends.
3.5.2

Straight Through Cables (Black)

Standard Ethernet straight through cables are required when connecting the device to a
standard network hub or switch.
NOTE
Figure 15: Ethernet cross-over cables.
Figure 16: Straight through cables.
16
Start-Up Manual