Diagnostics - Siemens ET 200SP Manual

Configuring/address space
4.9 Explanation of parameters
4.9.4

Diagnostics

The technology module can trigger additional diagnostic interrupts when you enable the
diagnostic interrupts in the basic parameters. These diagnostic interrupts are processed in
an interrupt OB.
Group diagnostics
You use this parameter to specify whether a diagnostic interrupt is to be triggered for
following errors:
● Supply voltage fault (feedback bit ERR_PWR)
● Short-circuit or overload at sensor supply (feedback bit ERR_24V)
● Load voltage missing
● Overtemperature
The parameter is disabled in the default setting.
Diagnostics DQA
You use this parameter to specify whether a diagnostic interrupt "Error at digital outputs" is
to be triggered in the event of an error at the digital output DQA. Regardless of this, the
feedback bit ERR_DQA is set when an error occurs.
The parameter is disabled in the default setting.
Diagnostics DQB
You use this parameter to specify whether a diagnostic interrupt "Error at digital outputs" is
to be triggered in the event of an error at the digital output DQB. Regardless of this, the
feedback bit ERR_DQB is set when an error occurs.
The parameter is disabled in the default setting.
132
Technology Module TM Pulse 2x24V (6ES7138‑6DB00‑0BB1)
Manual, 05/2019, A5E35061186-AB