Siemens ET 200SP Manual page 92

Control bit/value
TM_CTRL_DQ
SW_ENABLE
RES_ERROR
Reserved
Technology Module TM Pulse 2x24V (6ES7138‑6DB00‑0BB1)
Manual, 05/2019, A5E35061186-AB
Explanations
You enable the technological function of the digital output with this bit.
0 means: SET_DQA and SET_DQB define states of DQn.A and DQn.B
•
1 means: Output sequence defines the state of DQn.A; DQn.B is always 0.
•
You activate the software enable with this bit. If you are using the hardware enable, it is com-
bined with the software enable.
0 means: Stop output
•
1 means: Start output
•
Use of the HW enable is activated through parameter assignment. The HW enable is controlled
externally using the digital input DIn.0.
You use this bit to reset the following feedback bits when errors are pending:
ERR_24V
•
ERR_DQA
•
ERR_DQB
•
ERR_LD
•
Reserved bits must be set to 0.
Configuring/address space
4.4 On/Off delay mode
91