Siemens ET 200SP Manual page 152

Article number
Switching capacity of the outputs
with resistive load, max.
•
on lamp load, max.
•
Load resistance range
lower limit
•
upper limit
•
Output voltage
Type of output voltage
•
for signal "0", max.
•
for signal "1", min.
•
Output current
for signal "1" rated value
•
Output delay with resistive load
"0" to "1", typ.
•
"0" to "1", max.
•
"1" to "0", typ.
•
"1" to "0", max.
•
Parallel switching of two outputs
for uprating
•
Switching frequency
with resistive load, max.
•
with inductive load, max.
•
on lamp load, max.
•
Total current of the outputs
Current per channel, max.
•
Current per group, max.
•
Current per module, max.
•
Isochronous mode
Isochronous operation (application synchro-
nized up to terminal)
Bus cycle time (TDP), min.
Jitter, max.
Technology Module TM Pulse 2x24V (6ES7138‑6DB00‑0BB1)
Manual, 05/2019, A5E35061186-AB
6ES7138-6DB00-0BB1
2 A
10 W; 1 W with High Speed output
12 Ω; 240 ohm with High Speed output
12 kΩ
DC
1 V
23.2 V; L+ (-0.8 V)
2 A; 0.1 A with High Speed output, observe derat-
ing
0 µs; With High Speed output, 4.5 µs with Stand-
ard output
0.8 µs; With High Speed output, 9 µs with Stand-
ard output
0 µs; With High Speed output, 4.5 µs with Stand-
ard output
0.8 µs; With High Speed output, 9 µs with Stand-
ard output
Yes
100 kHz; With High Speed output, 10 kHz with
standard output
100 kHz; With High Speed output, 10 kHz with
standard output
10 Hz
2 A
4 A
4 A
Yes
250 µs; with 1 channel configuration, 375 µs with
2 channel configuration
1 µs; typically ±
Technical specifications
151