When Components Run Out (If The Check Box "Stop System When Components Run Out" Is Not Checked On The "Operation Option" Screen) - JUKI KE-2070 Operation Manual

Operation manualⅠ
3.2 When components run out (If the check box "Stop system when
components run out" is not checked on the "Operation option" screen)
After the machine finishes placing all components that can be placed on boards, the
following screen appears and the mounter stops temporarily.
After replenishing the machine with components or
removing the cause of a component run-out error
(such as jamming of tape), select the <Retry>
button, and then press the <START> switch.
☆ Ignore: Skips a component that caused a component run-out error to produce the next PWB.
☆ Suspend: Suspends the current PWB production.
☆ Pick tracking: Uses a camera to execute the component pick-up position correction process.
☆ Supply: Allows you to set the number of components.
☆ View Laser Waveform: Displays the laser waveform. See Section 3.4 "When a laser sensor is
stained" for details.
☆ Display change: Switches the screens between the "Not placed" list and the "Feeder
Information."
☆ Change data: Allows you to change the Component data.
Error screen
How to handle an error
Causes of the error
① The stocked components run out.
② The machine failed to pick up a
component.
(Due to jammed peel-off tape or a
pick-up position error caused by
defective tape feeding)
When you press the
<CAMERA> button of the HOD
while the machine stops
because components run out,
you can recheck the pick-up
position where a component
run-out error occurred again.
If a component pick-up error is
substantial, perform a teaching
operation.
3− 2