JUKI KE-2070 Operation Manual page 3

CAUTION
All personnel engaged in the operation of the chip placer and its accessories (here after referred to as
"machines") including the operators, service and maintenance personnel are required to read through this safety
warning to make familiar with its handling to prevent accidents and injuries.
This "Warning: For the safe operation of machinery" instructions contain aspects that are not included in the
instruction sheet attached to the product.
The following symbols are used throughout this instructions and on the product for the better understanding of
various warning labels. Please make yourself familiar with the contents and act accordingly.
1) Danger levels
Parts of machinery the negligence or mishandling of which committed during the
operation, maintenance or other services on such parts will lead to severe accidents
involving serious personal injuries or even death.
DANGER
Parts of machinery the negligence or mishandling of which committed, or are left
unattended, during the operation, maintenance or other services on such parts may
cause potential danger to the personnel which may lead to injuries and/or even death.
WARNING
Parts of machinery the negligence or mishandling of which committed, or are left
unattended, during the operation, maintenance or other services on such parts may
cause the medium-to-light level of hazards to the personnel involved.
CAUTION
2) Warning, prohibition and directive marks
Warning, prohibition and directives are marked with the following symbols:
Your hands or clothes
may get caught by the
machines.
High voltage!!
Beware of electric
shocks.
It symbolizes a contact to a grounding wire.
To prevent accidents due to electric shock, turn off power supply if it is necessary to open the electrical
equipment box. For added precaution, open the lid of the box only after a lapse of more than five minutes.
Situations in Which It Is Necessary to Turn Off Power Supply
1. In the case of an abnormality or an accident, or in the event of power failure,
immediately turn off power supply.
2. In order to prevent accidents due to unintended start-up of the machine, carry out inspection, repair, or
cleaning of the machine only after turning off power supply.
3. When drawing out the power supply plug, do it by holding the plug itself, not the cord.
For the safe operation of machinery
Warning marks
Beware of moving parts.
Contacts with them may
cause injuries.
Beware of hot parts.
Contacts with them may
cause a burn.
Directive symbols
Matters of Caution Regarding Safety
To turn off power supply means to turn off a power supply switch and then to
draw out a power plug from a receptacle or to separate the power cable from
the supply side. Hereinafter the same.
It indicates the direction of turn.
DANGER
i
Beware of movable parts.
Contacts with them may
cause injuries.
If any load is imposed or you
lay your hand on the
machine, it may be
damaged.