Table of Contents
Advertisement
Operation manualⅠ
<Step 3> Set the support pins.
① Set the support pins on the support table according to the shape of the board.
Support table
② After placing the board on the conveyor, raise the "Support table" on the
"Independent control of conveyor" dialog box.
③ Check each support pin position. Then, push the board from above with the hand
lightly to check to see if the board is supported with the support pins.
Support pin
2− 8
* Check to see if any substance
such as a chip is not stuck to
the bottom of the support pin.
* To mount components on both
sides of a board, set the
support pins so that no pin can
be in contact with components
already placed on the bottom
side of the board.
1. Select the <Support table> button.
2. Enter the board thickness by
appending a minus symbol (-).
Example: When the board thickness is
1.6 mm
Enter "- 1.600."
3. Raise or lower the table by
selecting the <ON>, <OFF>
and/or <ON/OFF> button(s).
Hide quick links:
Advertisement
Table of Contents
