JUKI KE-2070 Operation Manual page 17

Operation manualⅠ
Step 5 Set a board.
When you change the size of a board, you have to adjust the conveyor width and the
position of the pusher X to the size of a board.
* This manual describes how to adjust the standard shape reference machine.
Refer to Section 2.7.1.3 "Pin reference adjustment" of the "Instruction Manual CD"
for how to adjust the pin reference (optional) machine.
<Step 1> Adjust the width of the board transport rail to a board.
① Loosen the adjustment stopper, and turn the adjustment handle to move the pusher
X toward the IN buffer.
② Turn the handle knob to adjust the width of the board transport rail to a board to be used.
1. Loosen the setscrew of
2. When you turn the
Turn the handle knob to adjust the width
of the board transport rail.
* After adjustment,
Adjust the rail width so that
the distance between the
board and the rail can be 0.5
mm to 1 mm.
Check to see if a board can
be transported smoothly
over the transport rail.
2− 6
the adjustment stopper.
adjustment handle, the
pusher X starts moving.
3. Move the pusher X
toward the IN buffer.
remove the handle
knob.