Identifying A Part By Using The Hmc; Starting The System; Starting A System That Is Not Managed By An Hmc; Starting A System By Using The Control Panel - IBM Power Systems 9008-22L Manual

Procedure
1. On the ASMI Welcome pane, specify your user ID and password, and click Log In.
2. In the navigation area, expand System Configuration > Service Indicators > Enclosure Indicators.
All servers and enclosures managed by the ASMI will be displayed.
3. Select the server or enclosure that has the part to be replaced and click Continue. The location code
identifiers are listed.
4. Select the location code identifier and select Identify.
5. To save the changes made to the state of one or more FRU indicators, click Save settings.

Identifying a part by using the HMC

You can use the following procedures to activate light-emitting diodes (LEDs) by using the Hardware
Management Console (HMC).
About this task
You can use the identify LED for a FRU associated with a specified enclosure to help you identify a part.
For example, if you want to hook up a cable to a specific I/O adapter, you can activate the LED for the
adapter, which is a field replaceable unit (FRU). Then, you can physically check to see where you should
hook up the cable. This action is especially useful when you have several adapters with open ports.
Procedure
1. In the navigation area, click the Resources icon
2. Click the system name for which you want to activate the attention LED.
3. In the navigation area, click System Actions > Attention LED > Identify Attention LED. The Identify
LED, Select Enclosure window is displayed.
4. To activate an identify LED for the enclosure, select an enclosure and then click Activate LED. The
associated LED is turned on and is flashing.
5. To activate an identify LED for one or more FRUs in the enclosure, complete the following steps:
a. Select an enclosure and then click List FRUs.
b. Select the FRUs for which you want to activate the identify LED and click Activate LED. The
associated LED is turned on and is flashing.

Starting the system

Learn how to start a system after performing a service action or upgrading a system.

Starting a system that is not managed by an HMC

You can use the power button or the Advanced System Management Interface (ASMI) to start a system
that is not managed by a Hardware Management Console (HMC).

Starting a system by using the control panel

You can use the power button on the control panel to start a system that is not managed by a Hardware
Management Console (HMC).
Procedure
1. Open the front rack door, if necessary.
2. Before you press the power button on the control panel, ensure that power is connected to the system
unit as follows:
34
Power Systems: System processor modules for the 9008-22L, 9009-22A, or 9223-22H
, and then click All Systems.