Removing A Part By Using The Hmc; Repairing A Part By Using The Hmc - IBM Power Systems 9008-22L Manual

3. In the navigation area, click Serviceability.
4. In the Serviceability window, click Add FRU (field replaceable unit).
5. In the Add/Install/Remove Hardware-Add FRU, Select FRU Type window, select the system or
enclosure into which you are installing the feature.
6. Select the type of feature you are installing, and click Next.
7. Select the location code where you will install the feature, and click Add.
8. After the part is listed in the Pending Actions section, click Launch Procedure and follow the
instructions to install the feature.
Note: The HMC might open external instructions for installing the feature. If so, follow those
instructions to install the feature.

Removing a part by using the HMC

Learn how to remove a part by using the Hardware Management Console (HMC).
About this task
To remove a part in a system or an expansion unit by using the HMC, complete the following steps:
Procedure
1. In the navigation area, click the Resources icon
2. Click the system name for which you want to remove a part.
3. In the navigation area, click Serviceability.
4. In the Serviceability window, click Remove FRU.
5. In the Add/Install/Remove Hardware - Remove FRU, Select FRU Type window, select the system or
enclosure from which you are removing the part.
6. Select the type of part that you are removing, and click Next.
7. Select the location of the part that you are removing, and click Add.
8. After the part is listed in the Pending Actions section, click Launch Procedure and follow the
instructions to remove the part.
Note: The HMC might display the IBM Knowledge Center instructions for removing the part. If so,
follow those instructions to remove the part.

Repairing a part by using the HMC

You can use the Hardware Management Console (HMC) to complete many service actions, including
repairing a field-replaceable unit (FRU) or part.
Procedure
1. In the navigation area, click the Resources icon
2. Click the system name for which you want to remove a part.
3. In the navigation area, click Serviceability.
4. In the Serviceability window, click Serviceable Events Manager.
, and then click All Systems.
, and then click All Systems.
Common procedures for removing or replacing the system processor module
51