System Covers; Removing The Front Cover From A 9008-22L, 9009-22A, Or 9223-22H System - IBM Power Systems 9008-22L Manual

About this task
By default, the managed system is set to power off automatically when you shut down the last running
logical partition on the managed system. If you set the managed system properties on the HMC such that
the managed system does not power off automatically, you must use this procedure to power off your
managed system.
Attention: Ensure that you shut down the running logical partitions on the managed system before you
power off the managed system. Powering off the managed system without shutting down the logical
partitions first causes the logical partitions to shut down abnormally and can cause data loss. If you use a
Virtual I/O Server (VIOS) logical partition, ensure that all clients are shut down or that the clients have
access to their devices by using an alternative method.
To power off a managed system, you must be a member of one of the following roles:
v Super administrator
v Service representative
v Operator
v Product engineer
Note: If you are a product engineer, verify that the customer has shut down all active partitions and
has powered off the managed system. Continue with the procedure only after the status of the server
changes to Power Off.
Procedure
1. You must shut down all the active logical partitions before powering off the system. To shut down
logical partitions for a specific system, complete the following steps:
a. In the navigation area, click the Resources icon
b. Click the system name for which you want to shut down partitions.
c. Select the logical partitions that you want to shut down.
d. In the content pane, click Actions > Shutdown.
e. Click Finish.
2. To power off the system, complete the following steps:
a. In the navigation area, click the Resources icon
b. Select the system that you want to power off.
c. In the content pane, click Actions > View All Actions > Power Off.
d. Click Finish.

System covers

Use these procedures to remove and replace the covers on the 9008-22L, 9009-22A, or 9223-22H system.
Removing the front cover from a 9008-22L, 9009-22A, or 9223-22H
system
Use this procedure to remove the cover from a rack-mounted IBM Power System L922 (9008-22L), IBM
Power System S922 (9009-22A), or IBM Power System H922 (9223-22H) server.
Common procedures for removing or replacing the system processor module
, and then click All Systems.
, and then click All Systems.
39